HyperWorks Desktop 2017.2.3 릴리즈

이번 HyperWorks Desktop 2017.2.3 핫픽스에서는 HyperMesh, HyperView, HyperGraph, OptiStruct, RADIOSS, HyperCrash, MotionView, NVH Director 및 HyperWorks Verification and Validation Harness (HVVH)에 대한 성능 향상, 버그 수정이 포함되어 있습니다.

자세한 내용은 릴리즈 노트를 참조하시기 바랍니다.

HyperWorks Desktop 2017.2.3 릴리즈 노트 다운받기



HyperWorks Desktop 2017.2.3 공식 업데이트의 상세한 내용은 아래와 같습니다.

HyperMesh

CAD
New Features and Enhancements

• Support added for NX 12.0 (native reader)

Meshing
New Features and Enhancements

• Direct Midmesh

Direct midmesh targets a wide variety of manufactured parts including cast, machined, extruded, and injection molded.
The capability is generic and is applicable to model build in automotive, aerospace, heavy industry, consumer goods, plus other industries.
The new capability significantly improves efficiency by reducing model build times.
The ability to go from a representative part – whether CAD or volumetric FE – to a 2D midmesh
output is now possible. It bypasses the need to generate 2-d surface geometry first.
Direct midmesh is available via a new panel and is also available via BatchMesher.
Generating a new midmesh representation within the Part Browser is also now possible.
The example below shows some of the cases where direct midmesh may be used within automotive model build:

스크린샷 2018-07-04 오전 11.41.54

The recommended workflow can be seen in the diagram below. Performing a direct midmesh operation and extracting a 2mm output provides good correlation to the original
topology. There are several options to organize the output, control flat edges, flatten connections plus other options. Further details can be found in the PDF documentation.

This entry was posted in Updates, 미분류, 새소식.

Comments are closed.